SKU: 36823358912
Ships within 48 hours · Estimated delivery Sep 5 - Sep 10
This breakout drives the LEDs using Pulse Width Modulation (PWM)
Note: Please be aware that the CCS811 datasheet recommends a burn-in of 48 hours and a run-in of 20 minutes (you must allow 20 minutes for the sensor to warm up and output valid data)
Red LED is on - A very large current has been detected
One green power LED
2x1A DC Motor Shield for Arduino Shipping:2-4 Weeks This breakout drives the LEDsThis DC Motor shield for Arduino uses L293 chip which allow to drive two 7 12V DC motors with maximum 1A current each channel. This shield can be directly stacked on standard Arduino Uno and Arduino Mega . JavaScript displays Motor Drive Expansion Board Selection Guide Product Name 2x1A DC Motor Shield for Arduino Micro: bit Driver Expansion Board Gravity: Dual Bipolar Stepper Motor Shield for Arduino (DRV8825) Quad DC Motor Driver Shield for Arduino
US$ 228.00
US$ 1267.50
US$ 369.00
US$ 183.00
US$ 122.50
US$ 160.00
US$ 1009.50
US$ 145.00
US$ 182.00
US$ 352.00
US$ 171.00
