Adafruit DPI TFT Kippah for Raspberry Pi Shipping:2-4 Weeks Power can be connected to

Power can be connected to the module either from an 9v AC transformer to the two pin screw terminals

as it uses fewer pins: analog 4 and 5 are used for I2C (of course you can still connect other I2C devices to the bus)

This shield uses SPI for the display and SD card and is easier to use with UNO

com/products/13637)

Adafruit DPI TFT Kippah for Raspberry Pi Shipping:2-4 Weeks Power can be connected toA TFT panel connected to a Raspberry Pi without the use of an HDMI decoder? What is this sorcery??? It's the DPI Kippah from Adafruit ! This HAT like* board snaps onto a Raspberry Pi B+, A+, Pi 2, Pi 3 or Zero and with a little software configuration, allows you to have what normally would go out the HDMI port come up on a nice little flat screen. * Its not technically a HAT due to the lack of an on board EEPROM, but its the same shape as a Pi HAT and